
A customer machines a wide variety of parts with slight variations in overall length on a single turning machine. Because of these dimensional differences, it is difficult to use a standardized set of main chuck jaws across all part types.
As a result, jaw changeovers are often required whenever production shifts to a different workpiece.
These frequent changeovers increase setup time, reduce machine utilization, and impact overall productivity.
The customer therefore sought a solution that would minimize changeovers and improve operational efficiency.
To address this challenge, Muratec proposed an automatic locating adjustment system.
Rather than relying on the main chuck jaws to position each workpiece, the solution incorporates a locator (stopper) that references the workpiece from its chuck-side end face.
The servo-driven locator automatically adjusts to accommodate different workpiece lengths, reducing setup requirements, minimizing changeovers, and improving overall operating efficiency.
As a result of implementing Muratec's solution, main chuck changeovers were eliminated.
In addition, the servo-driven locator allows position settings to be called directly from the machining program. Because no separate screens or external devices are required during changeovers, the potential for operator error is significantly reduced.
Note: The servo locator system requires a hollow-type main chuck.
RELATION
CONTACT
If you have any questions, please contact us here